Installation Step 10
Install the Lights and Lens
•Install a 100 watt maximum light bulb in each socket. The lights will turn ON and remain lit for approximately
•Insert bottom lens tabs into slots on chassis and tilt towards chassis to engage top tabs, then drop down gently into place. (See illustration.)
•To remove, lift lens up and gently tilt slightly outward and down, then pull out to clear bulbs. Use care to avoid snapping off bottom lens tabs.
•If the bulbs burn out prematurely, replace with standard neck Garage Door Opener bulbs. (Fluorescent bulbs are not recommended because of possible interference with receiver/transmitter signals.)
CONTROL
CENTER
Light Socket
Bottom Lens Slot
Bottom Lens Tab
100 Watt Max.
Light Bulb
Top Lens Slot
Top Lens Tab
CONTROL
CENTER
Lens
Chassis | Insert Bottom Lens Tabs First |
Installation Step 11
Attach the Manual Release Rope and Handle
WARNING
Do not use the red handle to pull the door open or closed. The rope knot could become untied and you could fall. Use the manual release only to disengage the trolley and, if possible, only when the door is closed.
Trolley
Trolley
Release Arm
NOTICE
Overhand
Knot
Overhand
Knot
Rope
Manual
Release Handle
Garage doors are heavy. If the door is open when the handle is pulled, the door could close inadvertently if it is not properly balanced. Serious injury may result to persons under the door. Make sure the doorway is clear of persons and obstructions before pulling handle when door is open.
•Thread one end of the rope through the hole in the top of the red handle so “NOTICE” reads right side up as shown. Secure with an overhand knot at least 1" from the end of the rope to prevent slipping.
•Thread the other end of the rope through the hole in the release arm of the outer trolley.
•Adjust rope length so the handle is 6 feet above the floor. Secure with an overhand knot .
If it is necessary to cut the rope, heat seal the cut end with a match or lighter to prevent unraveling.
23