All ONE-PIECE Doors
Assemble the Door Arm:

•Fasten the straight and curved door arm sections together to the longest possible length (with a 2 or 3 hole overlap).

•With the door closed, connect the straight door arm section to the door bracket with the 5/16"x1-1/4" clevis pin.

•Secure with a ring fastener.

Door

Ring

 

 

Fastener

 

 

Bracket

 

 

 

 

Nuts

 

 

Lock

 

 

5/16"-18

 

 

Washers

 

 

 

 

 

5/16"

 

Clevis Pin

Straight

 

 

5/16"x1-1/4"

Arm

 

 

 

Screws

 

Curved

 

5/16"-18x7/8

 

 

 

 

Door Arm

Adjustment Procedures for One-Piece Doors

On one-piece doors, before connecting the door arm to the trolley the travel limits must be adjusted. Limit adjustment screws are located on the right side panel as shown on page 28. Follow adjustment procedures below.

Fully Closed

Trolley

Fully Open

Trolley

Door Arm

Door Arm

Door Arm

Connector Hole

Connector Hole

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Closed

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Door

Open Door

Door with

Door Arm

 

 

 

 

 

 

Backward Slant

 

 

 

 

 

Open Door Adjustment:

 

 

Closed Door Adjustment:

 

 

 

Decrease UP Travel Limit

 

 

Decrease DOWN Travel Limit

•Turn the UP limit adjustment screw counter-clockwise 5 1/2 turns.

•Press the Door Control push button. The trolley will travel to the fully open position.

•Manually raise the door to the open position (parallel to the floor), and lift the door arm to the trolley. The arm should touch the trolley just in back of the door arm connector hole. Refer to the fully open trolley/door arm positions in the illustration. If the arm does not extend far enough, adjust the limit further. One full turn equals 2" of trolley travel.

•Turn the DOWN limit adjustment screw clockwise 5 complete turns.

•Press the Door Control push button. The trolley will travel to the fully closed position.

•Manually close the door and lift the door arm to the trolley. The arm should touch the trolley just ahead of the door arm connector hole. Refer to the fully closed trolley/door arm positions in the illustration. If the arm is behind the connector hole, adjust the limit further. One full turn equals 2" of trolley travel.

Connect the Door Arm to the Trolley:

•Close the door and join the curved arm to the connector hole in the trolley with the remaining clevis pin. It may be necessary to lift the door slightly to make the connection.

•Secure with a ring fastener.

•Run the opener through a complete travel cycle. If the door has a slight "backward" slant in full open position as shown in the illustration, decrease the UP limit until the door is parallel to the floor.

27