Installation Step 13
Connect Door Arm to Trolley
Follow instructions which apply to your door type as illustrated below and on page 27.
SECTIONAL Doors Only
Make sure garage door is fully closed. Pull the manual release handle to disconnect the outer trolley from the inner trolley. Slide the outer trolley back (away from the door) about 2" as shown in Figures 1, 2 and 3.
Figure 1:
•Fasten straight door arm section to outer trolley with the 5/16"x1" clevis pin. Secure the connection with a ring fastener.
•Fasten curved section to the door bracket in the same way, using the
Figure 2:
•Bring arm sections together. Find two pairs of holes that line up and join sections. Select holes as far apart as possible to increase door arm rigidity.
Inner Outer
Trolley Trolley
Figure 1 |
| Figure 2 |
|
|
|
|
|
| |
Ring | Clevis Pin |
| Lock | Rope |
|
| |||
Fastener | 5/16"x1" | Washers |
| |
|
| Nuts | 5/16" |
|
|
|
|
| |
|
|
|
| |
|
|
|
| Manual |
|
|
|
| Release |
Door | Straight |
|
| Handle |
|
|
| ||
Door Arm |
|
|
| |
Bracket |
|
|
| |
|
|
|
| |
| Curved |
|
| Screws |
Clevis Pin | Door |
| ||
Door Arm |
| |||
|
| |||
Bracket |
|
| ||
|
|
| ||
|
|
|
|
Hole Alignment Alternative
Figure 3:
•If holes in curved arm are above holes in straight arm, disconnect straight arm. Cut about 6" from the solid end. Reconnect to trolley with cut end down as shown.
•Bring arm sections together.
•Find two pairs of holes that line up and join with screws, lock washers and nuts.
Figure 3 | Lock |
| Washers |
| 5/16" |
| Nuts |
|
Screws
Cut this end
Hardware Shown Actual Size
Nut | Lock Washer 5/16" | Ring Fastener |
|
|
|
|
|
| |||
|
|
|
|
|
| ||||||
|
|
|
| Clevis Pin |
|
|
|
| |||
Clevis Pin |
|
|
|
| Hex Screw | ||||||
|
|
|
| ||||||||
|
|
| |||||||||
5/16"x1" (Trolley) |
|
|
|
Proceed to Adjustment Step 1, page 28. Trolley will
26