Operation of Your Opener

Activate the opener with any of the following:

•The Remote Control Transmitter. Hold push button down until the door starts to move.

•The Door Control. Hold push button down until the door starts to move.

•The Outside Keylock or Keyless Entry. (See Accessories)

When the opener is activated with the safety reversing sensor installed and correctly aligned:

WARNING

Weak or broken springs could allow an open door to fall (either rapidly or unexpectedly), resulting in serious injury, death or property damage. If possible, use the manual release rope and handle only when the door is fully closed.

1.If open, the door will close. If closed, it will open.

2.If closing, the door will reverse.

3.If opening, the door will stop (allowing space for entry and exit of pets and for fresh air).

4.If the door has been stopped in a partially open position, it will close.

5.If obstructed while closing, the door will reverse.

6.If obstructed while opening, the door will stop.

7.The garage door will reverse in the closing cycle, and the opener lights will blink for 5 seconds, when the invisible beam is broken. If fully open, the door will not close when the beam is broken. The sensor has no effect in the opening cycle.

If the sensor is not installed, or is not aligned correctly, the door won't close from any remote transmitter. You can close the door with the Door Control, the Outside

Trolley

Trolley

ReleaseArm

(in Manual

Disconnect

Position)

NOTICE

Lockout position(Manual disconnect)
To open the door manually:

The door should be fully closed if possible. Pull down on the manual release handle (so that the trolley release arm snaps into a vertical position) and lift the door manually. The lockout feature prevents the trolley from reconnecting auto- matically, and the door can be raised and lowered manually as often as necessary.

Keylock, or Keyless Entry, however, if you activate them until down travel is complete. If you release them too soon, the door will reverse.

Opener Lights will turn on under the following conditions: When the opener is initially plugged in; when the power is interrupted; when the opener is activated. They will turn off automatically after 4-1/2 minutes or provide constant light when the Light feature is activated.

Lights will also turn on when someone walks through the open garage door. Bulb size is 100 watts maximum.

To reengage the trolley: Pull the manual release handle toward the opener at a 45° degree angle so that the trolley release arm is horizontal. The trolley will reconnect on the next UP or DOWN operation, either manually or by pressing the Door Control push button.

Trolley

Trolley

Release Arm

Manual

 

Release

NOTICE

Handle

 

(Pull at 45° angle)

To reconnect
Operation of the Door Control

(see page 21)

(See additional programming features, next page.)

Lighted Door Control Button: Press to open or close the door. Press again to reverse the door during the closing cycle or to stop the door while it's opening.

32