Charnwood Grosvenor Problem Solving, The gas pilot will not stay alight, Final Reminders

the top of the burner unit. Ideally a vacuum cleaner should be used, but if not a soft brush will do.

2.Check the condition of the coals. Any damaged ones will affect the efficient operation of the stove and should be replaced with new ones available from your stove supplier.

3.All gas joints should be checked to make sure they are completely sealed and that the gas supply and pressure is to specification.

4.The pilot jets are correctly set and clear of obstruction.

5.The chimney should also be checked to make sure there are no restrictions or blockages.

6.Finally re-lay the coals and light the stove as described earlier.

Problem Solving

Although we recommend that the customer is familiar with the following it is important that the installation engineer is contacted to rectify any difficulties.

The gas pilot will not stay alight:

1.Ensure there is a gas supply to the property and that the isolation tap is in the "on" position.

2.Hold the control knob in the lighting position for at least

20seconds once the burner is alight, to ensure adequate heat operation of the safety thermocouple valve.

3.Make sure that the pilot injector is not obstructed or blocked and that it is free from dust or dirt.

4.Finally ensure that the thermocouple, a very delicate electro-mechanical device, has not become damaged in any way. If it is damaged a replacement pilot assembly should be obtained and fitted by your installation engineer.

FINAL REMINDERS

We remind you that it is a legal requirement that the stove is installed by a qualified and accredited installation engineer. Improper installation, adjustment, alteration, service or maintenance can cause injury and/or damage to property.

If you are in the slightest doubt about any aspect of your stove's performance or you require additional information then please contact your stove supplier or qualified installation engineer.

At the risk of stating the obvious, please do not store, keep or use petrol or any other flammable liquids, vapours or substances anywhere near the stove or any other heating appliance.

We hope these instructions have been clear and helpful and you are now able to enjoy the full benefit of your stove. If you have any queries or have found any part not as straight forward as you would like, then please don't hesitate to call us. Any suggestions for improvements are most welcome.

Please keep these instructions handy for future reference.

Most Important: Before installing the stove, check the burner data plate, this must correspond with the type of gas which is to be used, i.e. Natural Gas or LPG.

Page 5

SV 2/00