|
| Setup |
|
| |
Replacing Gobos | The gobos in the Legend 1200E Spot’s gobo wheels are removable from their gobo | |
| plates. This operation is quite simple, although it requires the technician to be careful | |
| and to follow the recommended procedure. | |
| • | Make sure to disconnect the fixture’s power cord before replacing a gobo. |
| • | Always replace a gobo with a gobo of the same dimensions. |
| • | When inserting a glass gobo, always make sure that the shinny side of the |
|
| gobo (glass base) faces the lamp. This provides a layer of protection against |
|
| the high temperature from the lamp. |
| 1) | Turn the fixture off and disconnect it from the power outlet. |
| 2) | Open the head cover by loosening the four fastening screws at the sides of the top |
|
| cover. |
| 3) | Separate the gobo plate away from the gobo wheel by pushing it toward the front of |
|
| the moving head. Be careful not to push the gobo out of the gobo plate. |
| 4) | Once released from its slot, extract the gobo plate by pulling it outward. |
| 5) | On a flat surface, remove the expansion ring that holds the gobo in place and |
|
| remove the gobo from the gobo plate. |
| 6) | Insert a new gobo and hold it in place with the expansion ring. |
| 7) | Slide the tip of the gobo plate under the pressure plate near the center of the gobo |
|
| wheel. |
| 8) | Push the gobo plate inwards. DO NOT force the gobo plate into the gobo wheel slot. |
|
| If correctly installed, the gobo plate should accommodate itself in the gobo wheel |
|
| slot. |
Screws | Screws |
Cover Screws Location
Removed
Gobo
Gobo Removal Sequence
Legend™ 1200E Spot User Manual Rev. 03c |
