Operation
Lamp Off When DMX is Absent
Cooling Mode
Ignition Delay
Lamp Dousing
Display Settings
Display Reversal
Back Light Automatic Off
Back Light Intensity
Temperature Unit
Continued from previous page
When enabled (Yes), this option turns the lamp off when DMX signal is absent.
1)Select Off if DMX Off.
2)Select Yes or No
3)Press <ENTER>.
This option determines the speed of the cooling fans, whether always high or automatic.
1)Select Cooling Mode.
2)Select High or Auto.
3)Press <ENTER>.
When the State/Power On option is active, this setting configures the delay before the lamp strikes after power on.
1)Select Ignition Delay.
2)Select the ignition delay in seconds (000 to 255).
3)Press <ENTER>.
This option decreases the lamp power after the shutters/dimmers have been closed for a configurable time to reduce the internal heat accumulation.
1)Select Low Power Delay.
3)Select the time delay in seconds (000~255).
4)Press <ENTER>.
The options in the Display Settings section control the operation of the fixture’s LCD. To access this section, do the following:
1)Press <MENU>.
2)Select Display Settings.
3)Select the corresponding function as indicated below.
4)Press <MENU> to exit once you are done with this section.
This option reverses the LCD orientation (180º) to read it upright when the fixture is hanging from a truss.
1)Select On/Off.
2)Select Yes or No.
3)Press <ENTER>.
This option determines whether the LCD backlight will turn off automatically after 30 seconds of control panel inactivity.
1)Select Back Light Automatic Off.
2)Select Yes or No.
3)Press <ENTER>.
This option selects the intensity of the LCD backlight.
1)Select Back Light Intensity.
2)Select 1~10.
3)Press <ENTER>.
When enabled (Yes), this option turns the lamp on when DMX signal is present.
1)Select On if DMX On.
2)Select ºC (Celsius) or ºF (Fahrenheit).
3)Press <ENTER>.
Continues on the next page
Legend™ 1200E Spot User Manual Rev. 03c |