Operation
Factory Default
Offset Mode
Continued from previous page
If you want to default the fixture to its factory configuration, follow the following steps:
1)Select Factory Settings.
3)Select Yes (default fixture) or No (exit without defaulting).
4)Press <ENTER>.
•The above operation will default all the fixture’s parameters to their original factory configuration values.
•Defaulting the fixture does not affect the home position settings.
The Offset Mode provides fine adjustments for the home position of all the moving parts in the optical path as well as the pan and tilt movements. The home position is where the moving parts go when you reset them. In their corresponding home position, the moving parts should not show any border or reduce the light output. If they do, use the Offset Mode to fine adjust them.
Entering Offset Mode
Pan Motor
1)Press <MENU> to enter the regular Menu Mode.
2)Press <ENTER> for more than three seconds to enter the Offset Mode (the Offset Mode menu will show).
4)Press <MENU> to exit once you are done with offset adjustments.
1)Select Pan and press <ENTER> (a pop up window will open).
a)Select the new value
b)Accept the new value.
Tilt Motor
Shutter Motor
1)Select Tilt and press <ENTER> (a pop up window will open).
a)Select the new value
b)Accept the new value.
1)Select Shutter and press <ENTER> (a pop up window will open).
a)Select the new value (0~255).
b)Accept the new value.
Color Motor
Cyan Dichroic Flag Motor
1)Select Color 1 and press <ENTER> (a pop up window will open).
a)Select the new value
b)Accept the new value.
1)Select Cyan and press <ENTER> (a pop up window will open).
a)Select the new value (0~255).
b)Accept the new value.
Magenta Dichroic Flag Motor
Yellow Dichroic Flag Motor
3200 K Filter Dichroic Flag Motor
Gobo 1 Motor
1)Select Magenta and press <ENTER> (a pop up window will open).
a)Select the new value (0~255).
b)Accept the new value.
1)Select Yellow and press <ENTER> (a pop up window will open).
a)Select the new value (0~255).
b)Accept the new value.
1)Select 3200 K Filter and press <ENTER> (a pop up window will open).
a)Select the new value (0~255).
b)Accept the new value.
1)Select Gobo 1 and press <ENTER>.
a)Select the new value
b)Accept the new value.
Continues on the next page
Legend™ 1200E Spot User Manual Rev. 03c |