Chauvet LX10 user manual Operating Instructions, Troubleshooting, Switch, LEDs, Motor, Auto, Stop

4.OPERATING INSTRUCTIONS

The LX10 can operate in Sound-Active, Auto, or static mode. The mode is determined by the position of the switch located on the rear of the unit. To switch between the three modes, place the switch in either the “I” or “II” position for movement or “O” for static operation.

In the “II” position, the fixture operates in Sound-Active mode, the sensitivity of which can be adjusted by the knob also located on the rear of the unit. To increase the sensitivity of the unit rotate the knob clockwise.

In the “I” position the fixture operates in Auto mode. The light will progress through a pre- programmed routine, whether sound is present or not.

In the “O” position the fixture operates in static mode. The fixture will continue to light without scanner movement.

Switch	LEDs	Motor
I	Auto	Auto
O	Auto	Stop
II	Sound	Sound

Troubleshooting

1)Verify that the unit is plugged into both the wall and the unit, and verify that the fuse is in working order.

2)If the unit fails to respond, place the unit in auto mode, listening for movement of the motor inside the case. If no sound is heard from inside the case, replace fuse and retry.

3)If the unit is still not working, verify the integrity of the outlet with another fixture.

If you still have a problem after trying the above solutions, please contact CHAUVET Technical Support at the location on the next page.

LX10 7 2/7/2012 10:22 AM