inlet/ Filter (18), and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3.To clean, remove excess water from the Pump by tipping the unit on both sides to drain any remaining water from the inlet and outlet fittings. Drain the Detergent Dispenser and flush with running water. Use only a clean cloth and mild deter- gent to clean the body of the Pressure Washer. Do not use solvents. Do not im- merse any part of the tool in liquid. Dry off any remaining water on all parts and fittings. Then engage the Trigger Safety Lock.
4.When storing, always completely empty the Pressure Washer of water. Frost will damage the Pressure Washer if the unit contains water. Store the Pressure Washer indoors in a dry,
5.To Clean The Nozzle:
Aclog in the Nozzle (19A) can significantly reduce the amount of water that comes out of the Pressure Washer. A clog can also cause the unit to pulsate while in use. To clean out the Nozzle:
A.Turn off the Pressure Washer, and unplug the unit from its electrical outlet.
B.Turn off the cold water supply.
C.Release any remaining water pressure in the Pressure Washer by squeez- ing the Trigger (23A) in a safe direction. (See Figure H, page 13.)
D.Remove the Spray Wand Extension (11A) from the Gun. (See Figure F.)
E.Rotate the Knob (16A) to the High Impact Stream setting. (See Figure J.)
F.Insert the tip of a Tip Cleaner (not included) or thin (about 1/32” dia.), rigid, wire into the end of the Nozzle hole and rotate the Tip Cleaner back and forth until the debris is dislodged. Then, remove the Tip Cleaner or wire.
(See Figure K.)
SPRAY WAND EXTENSION (11A)
|
|
|
|
| |
|
|
|
|
| |
FIGURE K |
|
| TIP CLEANER | ||
KNOB (16A) | |||||
(NOT INCLUDED) | |||||
|
|
| |||
SKU 92146 | For technical questions, please call | PAGE 16 |
