Maintenance And Servicing
Risk of serious personal injury from accidental starting or electric shock. Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
Damaged equipment can fail, causing serious personal injury. Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, maintenance, and lubrication
1.BEFORE EACH USE, inspect the general condition of the tool. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation.
2.After Use, clean external surfaces of the tool with clean, moist cloth.
3.After each use, remove the Plastic Cover (34) and clean oil and sawdust out of the area underneath, especially the recess of
the Chain Tension Screw (40) and oil duct, with a damp cloth or compressed air to extend the life of the Pole Saw.
4. WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
5.Any repairs not specifically covered in this manual MUST be completed by a qualified service professional.
Troubleshooting
Problem |
| Possible Causes |
| Probable Solutions |
Pole Saw will not start | 1. | No power at outlet. | 1. | Check power at outlet. |
| 2. | Cord not connected. | 2. | Check that cord is plugged in. |
Pole Saw runs, but will | 1. | Chain is placed backwards on | 1. | Remove Chain and reattach |
not cut |
| Guide Bar |
| correctly |
Pole Saw only cuts when | 1. | Chain is dull. | 1. | Have Chain sharpened by |
forced. Cutting yields only |
|
|
| a professional sharpening |
sawdust and large chips |
|
|
| service. |
SKU 96405 | For technical questions, please call | Page 15 |
