CM2C40 | Installation Instructions |
Extended Programming Capabilities
The CM2C40 allows for extended programming to make the mount compatible with other devices such as a Universal Remote or other control devices through a serial connection.
Setting or changing the configuration of the CM2C40 is done through the remote control provided with the mount.
The remote control has a range of
NOTE: If operation of the mount is required at a greater distance than remote control will allow, the mount can be controlled through a hardwired switch or similar divice. See Dry Contact Closures on page 24 and (See figure 32) .
Normal Operating Mode
KEY | FUNCTION | REQUIRED ACTION |
1 | MOVE DISPLAY TO HOME | PRESS ONCE |
|
|
|
2 | RETRACT DISPLAY | PRESS ONCE |
|
|
|
3 | NOT USED | N/A |
|
|
|
4 | NOT USED | N/A |
|
|
|
5 | EXTEND DISPLAY | PRESS ONCE |
|
|
|
6 | PRESET POSITION 1 | NOT USED |
|
|
|
7 | PRESET POSITION 2 | NOT USED |
|
|
|
8 | PRESET POSITION 3 | NOT USED |
|
|
|
9 | SAVE PRESET POSITION | NOT USED |
|
|
|
10 | STOP* | PRESS ONCE |
|
|
|
The following table and illustration identify mount functionality and response by button on the remote control(s).
IMPORTANT ! : Power must be provided to mount and IR receiver must be installed in order to access extended programming options.
NOTE: To restore mount to factory default settings, enter setup mode and press the "PRESET III" button four times.
| 1 | 1 | 5 |
5 |
|
| 9 |
|
|
| |
3 | 4 |
|
|
|
| 3 | 4 |
6 | 2 |
|
|
|
|
| |
|
| 2 |
|
| 8 | 6 | 10 |
|
| ||
7 |
| 7 |
|
| 9 |
| |
|
|
| |
|
| 8 |
|
| MODEL: SC33A |
| MODEL: SE15 |
Figure 28 Remote Control Function
16
