Chief Manufacturing CM2C40 installation instructions Mount Installation

CM2C40 Installation Instructions

Mount Installation

The CM2C40 has been designed to be mounted either hanging from an overhead structure or mounted to existing stud wall structures. The following instructions assume a suitable mounting structure and surface exists prior to installation and all power and signal wires and cables have been properly installed.

IMPORTANT ! : The mounting pattern on the CM2C40 is 19" (483 mm) wide. If being mounted to an existing wall with 16" studs an additional stud will need to be added to each side in order for the mount to be installed.

WARNING: IMPROPER INSTALLATION CAN LEAD TO LIFT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installers responsibility to make certain the structure to which the lift is being mounted is capable of supporting 4 times the weight of the lift and all attached equipment.

To install the CM2C40:

1.If the display is installed and cables routed, disconnect wires and cables from display,and remove display.

2.Remove mount from wooden supports used during mount setup and configuration. and orient mount as shown in figure below.

WARNING: MOUNT WEIGHS IN EXCESS OF 40LBS! Always use two people and proper lifting techniques when installing or positioning mount.

3.Align mounting holes in baseplate with studs making sure mounting holes are centered on studs.

4.Locate vertical and horizontal position of mount. (See figure 15)

NOTE: The mount is designed to continue traveling 1/2" after the bottom cover makes contact with an object when being raised. If it is desired to use this feature this 1/2"

of travel must be considered when location the mount and a stop bar must be installed along the top edge of the opening in the ceiling. The stop bar must span the entire width of the front and back openings, and protrude outward into the opening a minimum of 1/2". See Bottom Cover Location Adjustment on page 14 and See (See figure 27)

5.Loosen four screws securing side mounting brackets to mount and adjust side mounting brackets until properly positioned against studs if applicable. (See figure 16)

6.Tighten four screws to hold position of side mounting brackets. (See figure 14)

3
	X4
5	X4
6

Figure 14

30.11" minus thickness of ceiling material	30.74" minus thickness of ceiling material
(If mounted to vertical studs)		(If hung from ceiling)

1 1/2" mimimum from back edge of bottom cover to wall or other surface

Figure 15

10