![](/images/new-backgrounds/1281030/28103019x1.webp)
LVS1U / LVSXU | Installation Instructions |
HANGING LVS1U/LVSXU MOUNT ON RAIL |
|
| wall | ||
Preparing Strut Channel (LVSXU only) |
|
|
| ||
|
|
| side | ||
1. On the top rail, slide one inner stop clamp (S) into end of |
|
| view | ||
strut channel section. (See Figure 6) |
|
|
|
| |
2. Fasten outer stop clamp (R) to inner stop clamp (S) using |
|
|
| ||
one |
|
|
| ||
3. Repeat for each end of each top section of strut channel. | 3 |
|
| ||
| Stop clamp fastened |
|
|
| strut channel |
| in place at each end |
|
| 3 | upper lip |
| of upper row of |
| lower strut |
| |
| strut channel |
| channel |
|
|
|
| (S) |
|
| mount hooks |
|
|
|
|
| |
| (R) | 1 |
|
|
|
2 | (T) |
|
| Figure 8 |
|
| 4. Tighten two hex head fasteners at bottom of each mount. | ||||
|
|
| |||
|
|
| (See Figure 8) |
|
|
Figure 6
Hanging Mounts
1.Lift mount and hang it on lower lip of upper strut channel or rail (V). (See Figure 7)
lower lip of strut |
channel or rail |
1 |
1 |
(LVS1U shown as example) |
Figure 7
2.Repeat for remaining mounts in that row, and slide mounts along strut channels to desired location.
3.LVSXU only: Add lower strut channel to bottom of all mounts in row by lifting strut channel up from below mounts and setting upper lip of strut channel onto mounts’ latching hooks. (See Figure 8)
RapidDraw |
|
pull cord |
|
5 | x 2 |
Figure 9
5.Fasten bottom rail (LVS1U) or lower strut channel (LVSXU) to wall using the provided hardware. See Parts drawing, and (See Table 2).
6.Extend RapidDraw pull cord to bottom row of displays so that it is accessible,
IMPORTANT ! : See Service section for more information on properly configurating the RapidDraw cord and display release.
7.Repeat Attaching Strut Channel or Rail and Hanging LVS1U/LVSXU Mount On Rail sections for each row of displays.
10