Chief Manufacturing LVS1U / LVSXU manual Strut Channel Requirements Lvsxu

LVS1U / LVSXU Installation Instructions

STRUT CHANNEL REQUIREMENTS (LVSXU)

IMPORTANT ! : Strut channel must be made of steel with a minimum yield strength of 33ksi (230MPa), and meeting the profile and dimension requirements outlined.

Table 1: Strut Channel Dimension Requirements

STEEL THICKNESS	DIMENSION (See Figure 2)
14 ga [0.075"] (2.5mm)	K = 13/16" (21mm)
12 ga [0.104"] (3mm)
	13/16" (21mm) < K < 3-1/4" (83mm)
14 ga or 12 ga
	L (minimum) = 1/4" (6mm)
	L (maximum) = 9/32" (7mm)

Strut Channel Profile 1-5/8" (41mm)

3/8"

7/8" (10mm) (22mm)

L

K

IMPORTANT! All dimensions other than "L" and "K" are nominal requirements.

UNACCEPTABLE strut channel profiles

Strut channel MUST have	Strut channel MUST NOT
rolled up lips on both sides	have holes or slots on
of channel.	side walls of channel.

Figure 3

Figure 2

MOUNTING PATTERN OFFSET CALCULATION

Center line of display

Center line of mounting pattern

Mounting pattern of display

Offset (H)

NOTE: An offset measurement (H) is required if the centerline of the display does not match the centerline of the display mounting pattern.

1.If display mounting pattern is BELOW display centerline: 8-3/4" - H = Distance from display centerline to rail mounting location.

2.If display mounting pattern is ABOVE display centerline: 8-3/4" + H = Distance from display centerline to rail mounting location.

Figure 4

8