Chief Manufacturing LVS1U / LVSXU manual Service, Extending and Retracting Mount

LVS1U / LVSXU Installation Instructions

SERVICE

Extending and Retracting Mount

The mounts may be extended and retracted only in a service situation.

1.To Extend Mount: Pull on the RapidDraw release cord designated for the specific mount.

2.When the mount releases, carefully grasp bezel edges of display and pull out slowly, being careful to clear surrounding displays.

3.To Retract Mount: Carefully push against display bezel edges, being careful to clear surrounding displays.

4.Push display against mount until it clicks into place.

Interface Bracket Kickstands

The interface brackets are equipped with kickstands which must only be used in a service situation.

1.Pull down on interface bracket release cords. (See Figure 22)

2.Pull out bottom of display.

3.Flip down the kickstands on both interface brackets, and prop against mount during service.

2	Kickstand
1
Interface bracket	3
release cords
(Display not shown)

Figure 22

4.After service, hold display while flipping up both kickstands.

5.Slowly bring bottom of display in towards mount until it clicks into place.

RapidDraw Display Release

The RapidDraw pull cord and display release allows easy service access to any specific display in the video wall.

Each mount ships with the pull cord installed. It is installed so that when pulled from below the mount or from the right of the mount it will release the display for service.

The following steps should be taken if an installation requires that the pull cord be accessible from the left of the display or above the display:

1.Unhook the pull cord from the mount. (See Figure 23)

2.Reinstall the pull cord in the opposite hole on the mount. (See Figure 23)

Mount ships with		To release display from
cord attached here	2 left or above,
		reinstall cord
		here

Figure 23

16