Chief Manufacturing LVS1U / LVSXU Completing the Installation, Fastener Installation Methods

LVS1U / LVSXU Installation Instructions

COMPLETING THE INSTALLATION

Cable Management Clips

1.Place cable clip (Q) into rail and turn 90° in either direction until cable clip is vertical. (See Figure 17)

2.Route cables and RapidDraw release cords along rails, through cable clips.

3.Fasten cables and cords to cable clips (Q) using cable ties

(P).

1

(Q)

Figure 17

Security

The displays may be secured to the mounts by using a padlock (not included) through the bottom of the interface brackets.

(See Figure 18)

NOTE: Padlock must have a 1/4" (6mm) shackle diameter.

Insert

padlock

Figure 18

FASTENER INSTALLATION METHODS

IMPORTANT ! : (See Table 2) for appropriate hardware and pilot hole sizes for various wall types.

Wood Stud

1.Use one 5/16" x 2-1/2" lag bolt (L) through product and into pilot hole. (See Figure 19)

2.Repeat for remaining pilot holes.

1

(L) x 2

2

Figure 19

Concrete

1.Install one UX10 x 60 anchor (J) into each pilot hole using a hammer, making sure that the anchor is flush with the wall. (See Figure 20)

2.Use one 5/16" x 2-1/2" lag bolt (L) through product into each anchor in wall.

	1	(J)
2	(L)

Figure 20

14