Chief Manufacturing LVS1U / LVSXU manual Adjustments

LVS1U / LVSXU Installation Instructions

ADJUSTMENTS

NOTE: The following steps are also referenced on the next page (See Figure 16) and the PowerZone Adjustment guide (Z).

1.Place the level against the front of the display and use knob (#1 in Figure 16) to straighten the tilt. (See Figure 12)

1

Figure 12

2.Place a level on top of display and use the knobs at the top of the interface brackets (#2 in Figure 16), to raise/lower each side of display and level the display. (See Figure 13) and (See Figure 16)

2 2

Figure 13

3.Place level across face of adjoining screens and adjust depth (#3 in Figure 16) to make displays flush across the front of the video wall. (See Figure 14) and (See Figure 16)

3

3

Figure 14

4.Slide latch mechanism until tab sits flush against the interface bracket.

5.Pull tab forward to lock latch mechanism to interface bracket. (See Figure 15)

6.Push latch down to engage the micro lateral adjustment knobs (#4B and #4C). (See Figure 15) and (See Figure 16)

7.Turn micro lateral adjustment knobs clockwise to move display toward knob end until displays are in correct position. (See Figure 16)

Tab	(Display not shown)
Latch	Interface
	bracket
4	5
	6

Figure 15

12