Cisco Systems 1400 Manufacturers Federal Communication Commission Declaration of Conformity Statement

B-2

Cisco Aironet 1400 Series Wireless Bridge Hardware Installation Guide. OL-4072-03

OL-4072-04

AppendixB Declarations of Conformity and Regulatory Information

Manufacturers Federal Communication Commission Declaration of Conformity Statement

Manufacturers Federal Communication Commission Declaration of Conformity Statement

Models: AIR-BR1410A-A-K9

AIR-BR-1410-A-A-K9-N

FCC Certification number: LDK 102047

LDK 102047P

Manufacturer: Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the l imits of a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a residential environment. This equipm ent generates,

uses, and radiates radio frequency energy, and if not installed and used in accordance with the

instructions, may cause harmful interference. However, there is no guarantee that interference will not

occur. If this equipment does cause interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to correct the interference by one of the

following measures:

•Reorient or relocate the receiving antenna.

•Increase separation between the equipment and receiver.

•Connect the equipment to an outlet on a circuit different from which the receiver is connected.

•Consult the dealer or an experienced radio/TV techni cian.

Caution The Part 15 radio device operates on a non-interference basis wit h other devices operating at this

frequency when using integrated antennas or those listed in Ta ble B- 1. Any changes or modification to

the product not expressly approved by Cisco could void the user’s authority to operate this device.

Caution To meet regulatory restrictions, the bridge with the antenna conn ec to r an d th e external antenna must be

be professionally installed.