20

Enter the following commands to configure the local ports on the East router with the dial-peer information in Table4:
East(config)# dial-peer voice 901 pots
East(config-dial-peer)# destination-pattern 19195558282
East(config-dial-peer)# port 1/0
East(config)# dial-peer voice 902 pots
East(config-dial-peer)# destination-pattern 19195559595
East(config-dial-peer)# port 1/1
East(config-dial-peer)# exit
East(config)#
These commands are summarized in Figure 15.
Figure15 East Router Configured for Local Dial Peers
Checking the Local Dial Peer Configuration
If you configured POTS dial peers on your router by following these examples, you can place calls between telephones connected
to the same router. You can also use the show dial-peer voice command to verify that the data that you configured is correct.
Note If the voice port is off line, use the interface configuration no shutdown command at the config-voice-port prompt to
enable it.
Calling Between Routers
To enable the West and East offices to send voice traffic to each other over the same IP network they use for data traffic, use a
WIC on each router to provide a connection to the IP network, as shown in Figure 16.
Table4 East Router Local Dial Peers

Telephone Number Destination Pattern Voice Port Dial-Peer Tag

919 555-8282 19195558282 1/0 901
919 555-9595 19195559595 1/1 902
dial-peer voice 901 pots
destination-pattern 19195558282
port 1/0
dial-peer voice 902 pots
destination-pattern 19195559595
port 1/1
FXS VIC
1/0
FXS VIC
1/1
East
22334
IP cloud