Cisco Systems 2600 Series manual Replacing the Cover

Installing the Redundant Power Supply Adapter Plate

Figure 11 Reconnecting the Connectors

10345

Six-pin

connector

Replacing the Cover

Take the following steps to replace the cover:

Step 1 Position the two chassis sections, as shown in Figure 2.

Step 2 Referring to Figure 2, press the two chassis sections together and ensure the following:

•The top section fits into the rear of the bottom section. The bottom section fits into the front of the top section.

•Each side of the top and bottom sections fits together.

Caution To fit the two sections together, it might be necessary to work them together at one end and then the other, working back and forth; however, use care to prevent bending of the chassis edges.

Step 3 When the two sections fit together snugly, slide the chassis top so until it fits into the front bezel.

Step 4 Replace the cover screws. Tighten the screws to no more than 8 or 9 inches/pound of torque.

Step 5 Reinstall the chassis on the wall, rack, desktop, or table.

Step 6 Reconnect all cables.

10Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers