46-10
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 46 Configuring Fallback Bridging
Monitoring and Maintaining Fallback Bridging
This example shows how to disable spanning tree on a port in bridge group 10:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# bridge group 10 spanning-disabled
Monitoring and Maintaining Fallback Bridging
To monitor and maintain the network, use one or more of the privileged EXEC commands in Table 46-2:
For information about the fields in these displays, see the Cisco IOS Bridging and IBM Networking
Command Reference, Volume 1 of 2, Release 12.2 from the Cisco.com page under Documentation >
Cisco IOS Software > 12.2 Mainline > Command References.
Tab l e 46-2 Commands for Monitoring and Maintaining Fallback Bridging
Command Purpose
clear bridge bridge-group Removes any learned entries from the forwarding
database.
show bridge [bridge-group] group Displays details about the bridge group.
show bridge [bridge-group] [interface-id |
mac-address | verbose]
Displays MAC addresses learned in the bridge group.