11-28
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 11 Configuring Interface Characteristics
Configuring the System MTU
Note You cannot configure a routing MTU size that exceeds the system MTU size. If you change the system
MTU size to a value smaller than the currently configured routing MTU size, the configuration change
is accepted, but not applied until the next switch reset. When the configuration change takes effect, the
routing MTU size automatically defaults to the new system MTU size.
Gigabit Ethernet ports are not affected by the system mtu command; 10/100 ports are not affected by
the system mtu jumbo command. If you do not configure the system mtu jumbo command, the setting
of the system mtu command applies to all Gigabit Ethernet interfaces.
You cannot set the MTU size for an individual interface; you set it for all 10/100 or all Gigabit Ethernet
interfaces on the switch. When you change the system or jumbo MTU size, you must reset the switch
before the new configuration takes effect.The system mtu routing command does not require a switch
reset to take effect.
Frames sizes that can be received by the switch CPU are limited to 1998 bytes, no matter what value was
entered with the system mtu or system mtu jumbo commands. Although frames that are forwarded or
routed are typically not received by the CPU, in some cases packets are sent to the CPU, such as traffic
sent to control traffic, SNMP, Telnet, or routing protocols.
Routed packets are subjected to MTU checks on the output ports. The MTU value used for routed ports
is derived from the applied system mtu value (not the system mtu jumbo value). That is, the routed
MTU is never greater than the system MTU for any VLAN. The routing protocols use the system MTU
value when negotiating adjacencies and the MTU of the link. For example, the Open Shortest Path First
(OSPF) protocol uses this MTU value before setting up an adjacency with a peer router. To view the
MTU value for routed packets for a specific VLAN, use the show platform port-asic mvid privileged
EXEC command.
Note If Layer 2 Gigabit Ethernet interfaces are configured to accept frames greater than the 10/100 interfaces,
jumbo frames received on a Layer 2 Gigabit Ethernet interface and sent on a Layer 2 10/100 interface
are dropped.
Beginning in privileged EXEC mode, follow these steps to change MTU size for all 10/100 or Gigabit
Ethernet interfaces:
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 system mtu bytes (Optional) Change the MTU size for all interfaces on
the switch that are operating at 10 or 100 Mb/s. The
range is 1500 to 1998 bytes; the default is 1500 bytes.
Step 3 system mtu jumbo bytes (Optional) Change the MTU size for all Gigabit
Ethernet interfaces on the switch. The range is 1500 to
9000 bytes; the default is 1500 bytes.
Step 4 system mtu routing bytes (Optional) Change the system MTU for routed ports.
The range is 1500 to the system MTU value, the
maximum MTU that can be routed for all ports.
Although larger packets can be accepted, they cannot be
routed.
Step 5 end Return to privileged EXEC mode.