Cisco Systems 3560 Configuring DHCP Auto-Image Update (Configuration File and Image)

3-12
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 3 Assigning the Switch IP Address and Default Gateway
Assigning Switch Information
Configuring DHCP Auto-Image Update (Configuration File and Image)
Beginning in privileged EXEC mode, follow these steps to configure DHCP autoconfiguration to
configure TFTP and DHCP settings on a new switch to download a new image and a new configuration
file.
Note Before following the steps in this table, you must create a text file (for example, autoinstall_dhcp) that
will be uploaded to the switch. In the text file, put the name of the image that you want to download (for
example, c3560-ipservices-mz.122-44.3.SE.tar). This image must be a tar and not a bin file.
This example shows how to configure a switch as a DHCP server so it downloads a configuration file:
Switch# config terminal
Switch(config)# ip dhcp pool pool1
Switch(dhcp-config)# network 10.10.10.0 255.255.255.0
Switch(dhcp-config)# bootfile config-boot.text
Switch(dhcp-config)# default-router 10.10.10.1
Switch(dhcp-config)# option 150 10.10.10.1
Switch(dhcp-config)# option 125 hex
0000.0009.0a05.08661.7574.6f69.6e73.7461.6c6c.5f64.686370
Command Purpose
Step 1 configure terminal Enter global configuration mode.
Step 2 ip dhcp pool name Create a name for the DHCP server address pool and enter DHCP pool
configuration mode.
Step 3 bootfile filename Specify the name of the file that is used as a boot image.
Step 4 network network-number mask
prefix-length
Specify the subnet network number and mask of the DHCP address pool.
Note The prefix length specifies the number of bits that comprise the
address prefix. The prefix is an alternative way of specifying the
network mask of the client. The prefix length must be preceded
by a forward slash (/).
Step 5 default-router address Specify the IP address of the default router for a DHCP client.
Step 6 option 150 address Specify the IP address of the TFTP server.
Step 7 option 125 hex Specify the path to the text file that describes the path to the image file.
Step 8 copy tftp flash filename.tx t Upload the text file to the switch.
Step 9 copy tftp flash imagename.tar Upload the tar file for the new image to the switch.
Step 10 exit Return to global configuration mode.
Step 11 tftp-server flash:config.text Specify the Cisco IOS configuration file on the TFTP server.
Step 12 tftp-server flash:imagename.tar Specify the image name on the TFTP server.
Step 13 tftp-server flash:filename.txt Specify the text file that contains the name of the image file to download
Step 14 interface interface-id Specify the address of the client that will receive the configuration file.
Step 15 no switchport Put the interface into Layer 3 mode.
Step 16 ip address address mask Specify the IP address and mask for the interface.
Step 17 end Return to privileged EXEC mode.
Step 18 copy running-config startup-config (Optional) Save your entries in the configuration file.