Cisco Systems 3560 Displaying Auto Smartports and Static Smartports Macros

12-14
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 12 Configuring Auto Smartports Macros
Displaying Auto Smartports and Static Smartports Macros
This example shows how to display the cisco-desktop macro, to apply the macro and to set the access
VLAN ID to 25 on an interface:
Switch# show parser macro cisco-desktop
--------------------------------------------------------------
Macro name : cisco-desktop
Macro type : default
# Basic interface - Enable data VLAN only
# Recommended value for access vlan (AVID) should not be 1
switchport access vlan $AVID
switchport mode access
# Enable port security limiting port to a single
# MAC address -- that of desktop
switchport port-security
switchport port-security maximum 1
# Ensure port-security age is greater than one minute
# and use inactivity timer
switchport port-security violation restrict
switchport port-security aging time 2
switchport port-security aging type inactivity
# Configure port as an edge network port
spanning-tree portfast
spanning-tree bpduguard enable
--------------------------------------------------------------
Switch#
Switch# configure terminal
Switch(config)# interface gigabitethernet0/4
Switch(config-if)# macro apply cisco-desktop $AVID 25
Displaying Auto Smartports and Static Smartports Macros
To display the Auto Smartports and static Smartports macros, use one or more of the privileged EXEC
commands in Tabl e 12-5.
Tab l e 12-5 Commands for Displaying Auto Smartports and Static Smartports Macros
Command Purpose
show parser macro Displays all static Smartports macros.
show parser macro name macro-name Displays a specific static Smartports macro.
show parser macro brief Displays the static Smartports macro names.
show parser macro description [interface
interface-id]
Displays the static Smartports macro description for all interfaces or
for a specified interface.
show shell Displays information about Auto Smartports event triggers and
macros.