34-78
Catalyst 3560 Switch Software Configuration Guide
OL-8553-06
Chapter 34 Configuring QoS
Displaying Standard QoS Information
This example shows how to limit the bandwidth on a port to 80 percent:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# srr-queue bandwidth limit 80
When you configure this command to 80 percent, the port is idle 20 percent of the time. The line rate
drops to 80 percent of the connected speed, which is 800 Mb/s. These values are not exact because the
hardware adjusts the line rate in increments of six.
Displaying Standard QoS Information
To display standard QoS information, use one or more of the privileged EXEC commands in
Tabl e 34-15:
Tab l e 34-15 Commands for Displaying Standard QoS Information
Command Purpose
show class-map [class-map-name]Display QoS class maps, which define the match criteria to
classify traffic.
show mls qos Display global QoS configuration information.
show mls qos aggregate-policer
[aggregate-policer-name]
Display the aggregate policer configuration.
show mls qos input-queue Display QoS settings for the ingress queues.
show mls qos interface [interface-id] [buffers | policers |
queueing | statistics]
Display QoS information at the port level, including the buffer
allocation, which ports have configured policers, the queueing
strategy, and the ingress and egress statistics.
show mls qos maps [cos-dscp | cos-input-q |
cos-output-q | dscp-cos | dscp-input-q | dscp-mutation
dscp-mutation-name | dscp-output-q | ip-prec-dscp |
policed-dscp]
Display QoS mapping information.
show mls qos queue-set [qset-id] Display QoS settings for the egress queues.
show mls qos vlan vlan-id Display the policy maps attached to the specified SVI.
show policy-map [policy-map-name [class
class-map-name]]
Display QoS policy maps, which define classification criteria for
incoming traffic.
Note Do not use the show policy-map interface privileged
EXEC command to display classification information
for incoming traffic. The control-plane and interface
keywords are not supported, and the statistics shown in
the display should be ignored.
show running-config | include rewrite Display the DSCP transparency setting.