Cisco Systems 3750G manual Logging into the Controller, Click Save and Reboot

Step 32 Check or uncheck the Auto RF check box to enable or disable the controller radio resource management (RRM) auto-RF feature.

The auto-RF feature enables the controller to automatically form an RF group with other controllers. The group dynamically elects a leader to optimize RRM parameter settings, such as channel and send power assignments, for the group.

Step 33 Click Next. The Configuration Wizard Completed page appears.

Step 34 Click Save and Reboot.

Step 35 When prompted, click OK to confirm the reboot. The controller saves your configuration and reboots. The reboot process can take several minutes, so you might need to wait before accessing your web browser again.

Logging into the Controller

Follow these steps to log into the controller from the switch.

Step 1 Telnet to the switch by using the switch IP address.

Step 2 At the switch system prompt, enter session 1 processor 1, and press Enter. The session number is linked to the controller. If there are two switches and you want to access controller number 2, you would enter session 2 processor 1.

Step 3 When prompted, enter a valid username and password to log into the controller, and press Enter. The administrative username and password were assigned in the Configuration Wizard and are case sensitive.

20