Chapter 7 Provisioning: Configuring QoS for IP Telephony
Advanced IP Telephony Network Configuration
Configuring QoS on ATM Connections
The QPM IP Telephony wizard does not configure ATM connections. However, QPM includes templates that you can use to create policy groups for your ATM interfaces.
To configure QoS on ATM Connections:
Step 1 Create and bind virtual template interfaces on the ATM PVC.
For example, the bolded command in this configuration example shows the commands for binding virtual templates to the ATM PVC. See the configuration documentation for your device for information on creating virtual templates.
interface ATM4/0.60
protocol ppp
!
interface
ip address 10.200.60.1 255.255.255.252 ppp multilink
If you have already added the devices to QPM, rediscover the devices in QPM so that the virtual template interfaces are recognized. See Rediscovering Device Information, page
Otherwise, add the devices to QPM (see Adding Devices to the Device Inventory, page
Step 2 Create policy groups from these QPM templates, and assign them to the described interfaces.
•
•
Step 3 Deploy the policies. See Deploying Policies and QoS Configurations, page
Configuring QoS on ATM to Frame Relay Connections
Some networks use ATM at the main site, but Frame Relay at remote sites, for communicating between the main and remote sites. If your network uses this setup, you can use QPM’s ATM to Frame Relay IP telephony templates to deploy QoS on the ATM and Frame Relay interfaces.
To support IP telephony, low speed interfaces (less than 768kbps) must enable link fragmentation and interleaving. For ATM to Frame Relay connections, this can be done using Multilink PPP (MLP) over ATM or Frame Relay. This procedure describes how to configure this setup.
To configure QoS on ATM to Frame Relay Connections:
Step 1 Create and bind virtual template interfaces on the ATM PVC and the Frame Relay DLCI.
For example, the bolded commands in these configuration examples show the commands for binding virtual templates to the ATM PVC (Example
User Guide for CiscoWorks QoS Policy Manager 4.1.6
|
| |
|