1-9
Cisco Global Site Selector 4490 Hardware Installation Guide
78-15755-01
Chapter 1 Introduction
Hardware Features
Ethernet Port
Your GSS 4490 comes with one integrated dual-port Ethernet controller. This
controller provides an interface for connecting to 10-Mbps, 100-Mbps, or
1000-Mbps networks and support autonegotitate, full-du plex, or half-duplex
operation on an Ethernet LAN.
To access the Ethernet port, connect a Category 3, 4, or 5 unshielded twisted-pair
(UTP) cable to the RJ-45 connector on the back of the device.
Note The 100BASE-TX/1000BASE-TX Ethernet standard requires tha t the cabling in
the network be Category 5 or higher.
Figure 1-7 shows the pin number assignments for the Ethernet RJ -45 port.
Figure 1-7 Ethernet Port Connector
Console Port
Your GSS 4490 has one standard RS 232 serial port located on the back of the
device. Figure 1-8 shows the pin number assignments for the 9-pin, male D-she ll
serial port connector on the back of the GSS 4490. These pin number assignme nts
conform to the industry standard.
Link LED
(green)
Activity (TX/RX)LED
(green)
97447
81