Cisco Systems 520 series manual Configure Radio Station Subinterfaces, Bridge-group number

Chapter 9 Configuring a Wireless LAN Connection

Configure Radio Station Subinterfaces

	Command or Action	Purpose
Step 3
	bridge-group number	Assigns a bridge group to the interface.
	Example:
	Router(config-if)# bridge-group 1
	Router(config-if)#
Step 4
	bridge-group parameter	Sets other bridge parameters for the bridging
		interface.
	Example:
	Router(config-if)# bridge-group 1
	spanning-disabled
	Router(config-if)#
Step 5
	interface name number	Enters configuration mode for the virtual bridge
		interface.
	Example:
	Router(config-if)# interface bvi 1
	Router(config-if)#
Step 6
	ip address address mask	Specifies the address for the virtual bridge
		interface.
	Example:
	Router(config-if)# ip address 10.0.1.1
	255.255.255.0
	Router(config-if)#

Repeat Step 2 through Step 6 above for each VLAN that requires a wireless interface.

Configure Radio Station Subinterfaces

Perform these steps to configure subinterfaces for each root station, beginning in global configuration mode:

	Command	Purpose
Step 1
	interface type number	Enters subinterface configuration mode for the
		root station interface.
	Example:
	Router(config)# interface dot11radio 0.1
	Router(config-subif)#
Step 2
	description string	Provides a description of the subinterface for
		the administrative user.
	Example:
	Router(config-subif)# description Cisco open
	Router(config-subif)#

Cisco Secure Router 520 Series Software Configuration Guide

OL-14210-01 9-5