8
Attach the Cable-Management Bracket
Figure 6 Attaching the Cable-Management Bracket

Step 1 Align the cable-management bracket (1) to the rack-mount bracket on the left side of the Cisco 7301 router.

Step 2 Using a Phillips screwdriver and the M4 x 20-mm screw (2), thread and tighten the screw to the cable-management

bracket.

Go to the “Four-Post Rack Installation” section on page 8 or the “Two-Post Rack Installation” section on page 9.

Four-Post Rack Installation
Figure 7 Installing the Cisco 7301 Router in a Four-Post Rack

Note Inner clearance (the width between the inner sides of the two posts or rails) must be at least 17.3 inches (43.9 cm) The

height of the chassis is 1.73 inches (4.39 cm). Airflow through the chassis is from front to back.

1Cable-management bracket 2M4 x 20-mm screw

1Four-post rack 3Four 12-24 x 0.5-inch screws

2Screw hole for cable-management bracket

ENABLED
RX CELLSRX CARRIERRX ALARM
80278
1
2
ALARM
RJ45 EN LINK
TX RX
GBIC
GIGABIT ETHERNET 0/2
RJ45 EN LINK
TX RX
GBIC
GIGABIT ETHERNET 0/0
RJ45 EN LINK
TX RX
GBIC
GIGABIT ETHERNET 0/1
CISCO 7301SLOT 1
CONSOLE
AUX
COMPACT
FLASH STATUS
100-240V, 2A, 50/60 Hz
24V
=
9A, 48 - 60V
=
5A
BAENABLEDRX CELLSRX CARRIERRX ALARMATM
80908
1
2
3