Cisco Systems 78-10588-03 or defective terminal blocks

Chapter3 Installing the Chassis

Connecting Power

3-12

Cisco Metro 1500 Series Hardware Installation Guide

78-10588-03

Figure3-5 Rear Panel of the PSM (US Version)

Caution Donot use damaged terminal blocks. Immediately replace damaged

or defective terminal blocks

Step 3 Take a medium screwdriver and push it into the rectangular hole of the terminal

block.(See Figure 3-6.)At the same time, slide the insulation-free end of the wireintothe respective rectangular hole at the bottom of the power clamp. Repeat thisstep for the other wires.

Instructions for

power supply

Fan module

Fuse 2 Fuse 1

March 1999

For continued protection against risk of fire replace

only with same type and ratings of fuse.

For proper selection of power supply cord refer to

instruction manual.

Always remove both poewr cords whendisconnecting from a power source.Voltage: Power ConsumptionFuse: 2 115/230 V 50/60 HzMax. Current: 2.5 A max. 100 Wx T 2,5 A / 250 V

Made in Germany

Always remove both

power cords when dis-

connecting from power

source !

!

Terminal blocks Fuse

holders

Power 2 Power 1

50327

Contents

Main CHAPTER Installing the Chassis Before Installing Unpacking and Inspecting the System Maintaining a Network Record Mounting the System Installing the System Cisco Metro 1500 Series Hardware Installation Guide 78-10588-03 Chapter3 Installing the Chassis Installing the System POWER FAN Ch.1-8 Installing the NEMI Module To install a NEMI module (master and slave, as applicable), follow these steps: Step 1 Remove the acrylic front cover from the unit in which the module should be added. (See Figure 3-1.) Figure3-1 NEMI Placement in the Primary Chassis and Extension Chassis B. Page 78-10588-03 Chapter3 Installing the Chassis Installing the System METRO 1500 POWER FAN Installing the DEMI Module To install a DEMI module, follow these steps: Step 1 Remove the acrylic front cover from the unit in which the module should be added. (See Figure 3-2.) Figure3-2 DEMI Placement in Extension Chassis A and C Connecting Power Connecting AC Power To connect AC power, follow these steps: Figure 3-4.) unit. (See Figure 3-3.) Figure3-3 Rear Panel of the Cisco Metro 1500 (AC Version) on again. FAIL POWER OK FAILOK FAN METRO 1500 Serial Connecting DC Power Installing Terminal Blocks (US Version) Figure3-5 Rear Panel of the PSM (US Version) Caution Donot use damaged terminal blocks. Immediately replace damaged or defective terminal blocks Step 3 Take a medium screwdriver and push it into the rectangular hole of the terminal Instructions for power supply holders Terminal blocks Fuse Page The chassis powersup as soon as the corresponding power switch of the PDU is turned on. Installing the DC Plug-Socket Combination (European Version) 32268 ! To connect the power cables for the European version, follow these steps: Step 1 Connectthe desired power cables to power 1 and power 2 on the rear panel of the Page Page Power Consumption and Power Supply Fuses Grounding the Chassis Cleaning the System Cleaning the Chassis Cleaning the Connectors Page Removing the Power Supply Module Power On/Off Removing the Power Supply Module Figure3-10 Power Supply Modules WCM RSM MUX Power 1 Power 2 NEMI DMX MUX DMX Determining Power Supply Status Page Running Online Tests Verifying Connections Measuring Channel Outputs and Channel Budgets Page Troubleshooting