![](/images/new-backgrounds/1129107/12910741x1.webp)
Chapter 3 Installing the Chassis
Removing the Power Supply Module
•Cover the connector adapters to avoid soiling or contaminating the inside of the adapters while cleaning the chassis.
•Cover the connectors and adapters to avoid the inside of the adapters or the surface of the connectors from getting dirty when not using the connectors.
Note If the surface is not clean or does not have a uniform shine, repeat the process using a fresh surface of the alcohol pad.
Removing the Power Supply Module
This section describes how to power on the system, determine whether a power supply module (PSM) is faulty, and how to replace a PSM, if necessary.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
The Cisco Metro 1500 series system has two identical, fully redundant PSMs. Each PSM can cover the power needs of the entire system. These PSMs provide 5V and 30A to the system. The PSM provides full
Power On/Off
Caution If powered off, wait at least 10 seconds before you switch the unit on again.
Turn the power on or off using the keyswitch on the
|
| Cisco Metro 1500 Series Hardware Installation Guide |
|
|
|
|
| ||
|
|
| ||
|
|
|