Cisco Systems 78-10588-03 manual - page 6

Chapter3 Installing the Chassis
Installing the System
3-6
Cisco Metro 1500 Series Hardware Installation Guide
78-10588-03
Step 4 Insert the NEMI module carefully into the chassis slot while guiding the upper
andlower edges of the module in the tracks until its connectors come into contact
with the backplane connectors.
Caution It is critical to insert the module gently. If you need a force greater
than 1 lb (4.5 newton) to push in the module, stop immediately.
Inspect the electrical connector. If the connector is not damaged,
repeat Step 4.
Step 5 Hold the module in position after making full contact and use the two screwson
the front panel of the module to secure it in the housing. When the module is in
contact with the backplane, the green power LED is on.
Step 6 Reset the NEMI modules (both master and slave, if applicable) by inserting a
pointed tool into the small hole on the front panel within the first 30 seconds of
installation. The green power LED comes on and the NEMI module starts up.
Step 7 Save the blank filler panels with the packaging material.