Cisco Systems 78-10588-03

3-13

Cisco Metro 1500 Series Hardware Installation Guide

78-10588-03

Chapter3 Installing the Chassis Connecting Power

Figure3-6 Connecting Wires

Step 4 Connect the three wires on the other end to the corresponding high current

connectors of the power distribution unit. Attach the wires to their respective

points in the connectors.

Caution Makesure that the three wires of the power cables are correctly fixed

at the clamps of the PDU connectors.

Caution Never connect blue (negative) or brown (positive) wires to the

ground pin.

Step 5 Turn the power on using the corresponding power switch of the PDU.

Green/yellow wire (ground)

Blue wire (negative)

Brown wire (positive)

50328

Contents

Main CHAPTER Installing the Chassis Before Installing Unpacking and Inspecting the System Maintaining a Network Record Mounting the System Installing the System Cisco Metro 1500 Series Hardware Installation Guide 78-10588-03 Chapter3 Installing the Chassis Installing the System POWER FAN Ch.1-8 Installing the NEMI Module To install a NEMI module (master and slave, as applicable), follow these steps: Step 1 Remove the acrylic front cover from the unit in which the module should be added. (See Figure 3-1.) Figure3-1 NEMI Placement in the Primary Chassis and Extension Chassis B. Page 78-10588-03 Chapter3 Installing the Chassis Installing the System METRO 1500 POWER FAN Installing the DEMI Module To install a DEMI module, follow these steps: Step 1 Remove the acrylic front cover from the unit in which the module should be added. (See Figure 3-2.) Figure3-2 DEMI Placement in Extension Chassis A and C Connecting Power Connecting AC Power To connect AC power, follow these steps: Figure 3-4.) unit. (See Figure 3-3.) Figure3-3 Rear Panel of the Cisco Metro 1500 (AC Version) on again. FAIL POWER OK FAILOK FAN METRO 1500 Serial Connecting DC Power Installing Terminal Blocks (US Version) Figure3-5 Rear Panel of the PSM (US Version) Caution Donot use damaged terminal blocks. Immediately replace damaged or defective terminal blocks Step 3 Take a medium screwdriver and push it into the rectangular hole of the terminal Instructions for power supply holders Terminal blocks Fuse Page The chassis powersup as soon as the corresponding power switch of the PDU is turned on. Installing the DC Plug-Socket Combination (European Version) 32268 ! To connect the power cables for the European version, follow these steps: Step 1 Connectthe desired power cables to power 1 and power 2 on the rear panel of the Page Page Power Consumption and Power Supply Fuses Grounding the Chassis Cleaning the System Cleaning the Chassis Cleaning the Connectors Page Removing the Power Supply Module Power On/Off Removing the Power Supply Module Figure3-10 Power Supply Modules WCM RSM MUX Power 1 Power 2 NEMI DMX MUX DMX Determining Power Supply Status Page Running Online Tests Verifying Connections Measuring Channel Outputs and Channel Budgets Page Troubleshooting