Step9
Install Hood
|
| Installation |
| |
|
|
| 36" Island Vent Hood |
|
Align Duct |
|
| Bottom |
|
Connector to | Align |
| Duct |
|
| Cover |
| ||
House Duct | Mounting |
| ||
Stop Screw |
| |||
| Studs |
| Install | |
|
|
|
4 lock
washer
and 4 Nuts
Note: TWO PEOPLE ARE REQUIRED TO COMPLETE THIS INSTALLATION!
•Lift the hood up to the support frame. Carefully align the hood mounting studs into the support frame holes, and at the same time, guide the hood duct connector into the house duct.
•Install 4 nuts and lock washers to the mount- ing studs. Tighten with a 10mm wrench.
•Check hood level in both directions.
•Check to be sure that the duct is positioned over the hood connector.
•Seal the duct connection with duct tape. Note: Do not drive screws through lower duct connection. Doing so will prevent proper damper operation.
Step10
Connect Electrical
Verify that power is turned off at the source.
WARNING
If house wiring is not
When house wiring is aluminum, be sure to use U.L. approved anti- oxidant compound and alumi-
•Install strain relief into the knockout of the junction box cover.
•Insert house wiring through strain relief and tighten.
•Connect white leads to branch circuit white lead.
•Connect black leads to branch circuit black lead.
•Connect green/yellow leads to branch circuit green or bare ground lead.
•Secure all connections with wire nuts on each electrical connector.
•Push wires into junction box and replace cover. Be sure wires are not pinched.
12