Installation
36" Island Vent Hood
Step4
Mount Template
•Align the template with the marks on the ceiling and tape in place.
–Be sure the template is oriented correctly, with the front of the hood.
•Use a plumb to check to be sure the mount- ing holes will provide parallel alignment with the countertop below.
•Center punch all hole locations.
•Drill pilot holes in the 4 screw locations. Use a 5/32” bit and drill approximately
•Cut the
Front of Hood
Wire Access Hole
Step5
Install
Support
Frame
Upper
Support Front
Frame Of
Hood
Lower
Support
Frame
| Hood |
| Lower Support |
| Mounting | ||
|
| ||
| Flange |
|
|
|
|
| |
Support |
|
|
|
Frame |
|
| |
Opening |
| ||
|
| ||
Check Level in |
|
| |
|
| to Floor | |
Both Direction |
|
| Countertop |
|
|
|
Install upper support frame
•Secure the upper support frame to the ceiling joists and/or cross framing with the 4 screws provided. For maximum rigidity and strength, the screws must be driven into the center of the joists and/or cross framing.
•Check to be sure the support frame is level, vertically and horizontally.
*Note:
Install lower support frame
•Insert lower support frame (from required accessory ZX858, ZX859 or ZX8510) into the upper support frame and loosely secure with 8 screws and washers (4 on front and 4 on back sides).
•Adjust the lower support frame up or down to the desired height above the countertop. Tighten screws.
Important: Again, check to be sure the support is level in both directions. There is no way to level the hood after the hood is secured to the frame.
9