Installing the Cisco SFS 7008P Switch into a Rack
To install the Host Channel Expansion Card for IBM BladeCenter drivers after you have installed the HCA Expansion Card, follow these steps:
Step 1 Locate your downloaded software direcory.
Step 2 Open a terminal or graphic window and access the
Step 3 Execute the command ./tsinstall in a terminal window.
# cdmount ./tsinstall
This program automatically detects the available kernel and installs the appropriate drivers as RPM packages. By default, the files are saved in the /usr/local/cisco directory.
Step 4 Configure the IPoIB driver by assigning an IP address to interface ib0 and/or ib1, which corresponds to the two HCA ports. IPoIB drivers load when the interfaces are used for the first time. To assign ib interfaces, enter ifconfig ib# ip address netmask netmask.
This example configures one HCA:
#ifconfig ib0 192.168.0.1 netmask 255.255.255.0
#ifconfig ib1 192.168.1.1 netmask 255.255.255.0
This example configures two HCAs:
#ifconfig ib0 192.168.0.1 netmask 255.255.255.0
#ifconfig ib1 192.168.1.1 netmask 255.255.255.0
#ifconfig ib2 192.168.2.1 netmask 255.255.255.0
#ifconfig ib3 192.168.3.1 netmask 255.255.255.0
Step 5 Merge ib0 and ib1 for
Step 6 (Optional) Configure MPI by following these steps:
•Make sure that your connections to the HCA uses port 1 of the first HCA. MPI requires the use of HCA 1, port 1.
•Set up rsh or ssh on two nodes so that you can run commands between a remote and local node without entering a login or password. This is required to use the MPI protocol.
•Either add paths to your environment PATH:
/usr/local/cisco/mpi/mpich/bin
/usr/local/cisco/bin
or
Add directories to your PATH variable. For example:
export PATH=$PATH:/usr/local/cisco
Step 7 Configure all other drivers, including SDP.
|
| Cisco SFS 7008P InfiniBand Server Switch Installation and Configuration Note |
|
|
|
|
|
| |||
|
|
| 11 |
| |
|
|
|
|
