9-11
Cisco ASA Series Firewall CLI Configuration Guide
Chapter9 Getting Started with Application Layer Protocol Inspection
Configuring Application Layer Protocol Inspection
http [map_name] If you added an HTTP inspection policy map according to
the “Configuring an HTTP Inspection Policy Map for
Additional Inspection Control” section on page 10-16,
identify the map name in this command.
icmp —
icmp error —
ils —
im [map_name] If you added an Instant Messaging inspection policy map
according to “Configuring an Instant Messaging Inspection
Policy Map for Additional Inspection Control” section on
page 10-21, identify the map name in this command.
ip-options [map_name] If you added an IP Options inspection policy map according
to “Configuring an IP Options Inspection Policy Map for
Additional Inspection Control” section on page 10-25,
identify the map name in this command.
ipsec-pass-thru [map_name] If you added an IPsec Pass Through inspection policy map
according to “IPsec Pass Through Inspection” section on
page 10-25, identify the map name in this command.
ipv6 [map_name] If you added an IP Options inspection policy map according
to “(Optional) Configuring an IPv6 Inspection Policy Map”
section on page 10-27, identify the map name in this
command.
mgcp [map_name] If you added an MGCP inspection policy map according to
“Configuring an MGCP Inspection Policy Map for
Additional Inspection Control” section on page 11-12,
identify the map name in this command.
netbios [map_name] If you added a NetBIOS inspection policy map according to
“Configuring a NetBIOS Inspection Policy Map for
Additional Inspection Control” section on page 10-30,
identify the map name in this command.
pptp —
radius-accounting [map_name]The radius-accounting keyword is only available for a
management class map. See the “Creating a Layer 3/4 Class
Map for Management Traffic” section on page1-14 for more
information about creating a management class map.
If you added a RADIUS accounting inspection policy map
according to “Configuring a RADIUS Inspection Policy
Map for Additional Inspection Control” section on
page 13-9, identify the map name in this command.
rsh —
rtsp [map_name] If you added a RTSP inspection policy map according to
“Configuring an RTSP Inspection Policy Map for Additional
Inspection Control” section on page11-16, identify the map
name in this command.
Table9-2 Protocol Keywords
Keywords Notes