Cisco Systems ASR 9000, A9K24X10GETR, A9KMOD80TR manual Reloading a Failed Configuration, 3-30

Chapter 3 Configuring General Router Features

Managing Configuration Sessions

F I N A L D R A F T — C i s c o C o n f i d e n t i a l

Committing a Configuration from Global Configuration Mode: Example

In the following example, the default commit command is entered in global configuration mode:

RP/0/RSP0/CPU0:router# configure

RP/0/RSP0/CPU0:router(config)# interface Gi 0/0/0/2

RP/0/RSP0/CPU0:router(config-if)# description faq

RP/0/RSP0/CPU0:router(config-if)# ipv4 address 10.1.1.1 255.0.0.0

RP/0/RSP0/CPU0:router(config-if)# commit

RP/0/0/0:Aug 6 09:26:17.781 : %LIBTARCFG-6-COMMIT Configuration committed by user ‘cisco'. Use 'show configuration commit changes 1000000124' to view the changes.

Note The preceding message is stored in the log and displays only if logging is configured to display on screen.

Committing a Configuration from Administration Configuration Mode: Example

In the next example, the commit command is entered with the label and comment options in administration configuration mode:

RP/0/RSP0/CPU0:router# admin RP/0/RSP0/CPU0:router(admin)# configure RP/0/RSP0/CPU0:router(admin-config)# sdr test RP/0/RSP0/CPU0:router(admin-config-sdr:test)# location 0/1/* primary RP/0/RSP0/CPU0:router(admin-config-sdr:test)# commit label test comment This is a test RP/0/RSP0/CPU0:router(admin-config)# show configuration commit list detail

1) CommitId:	2000000018	Label:	test
UserId:	user1	Line:	vty1
Client:	CLI	Time:	23:45:40 UTC Wed Dec 02 2008
Comment:	This is a test

Note Configuration files are stored on the same flash disk as the boot image. Access these configurations only through the CLI commands for configuration management, history, and rollback. Direct modification or deletion of these files can result in lost router configurations.

Reloading a Failed Configuration

If the router displays a configuration failure message when you attempt to commit a configuration change, the configuration changes are not lost. While you remain in global configuration mode or administration configuration mode, you can load the configuration changes into the target configuration, correct the errors, and commit the changes. To load a failed configuration, go to global configuration or administration configuration mode and type the load configuration failed commit command, as shown in the following example:

RP/0/0/CPU0:router(config)# load configuration failed commit

RP/0/0/CPU0:router(config)# show configuration

Building configuration...

taskgroup alr

!

end

	Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
3-30	OL-17502-01