Cisco Systems ASR 9000, A9K24X10GETR manual Where to Go Next, Command or Action Purpose, Example

Chapter 1 Introducing to the Cisco ASR 9000 Series Aggregation Services Router

			Where to Go Next
		F I N A L D R A F T — C i s c o C o n f i d e n t i a l
	Command or Action		Purpose
Step 5
	Log in to the router.		Establishes your access rights for the router management
			session.
			• Type the root-system username and password or the
			username and password provided by your system
			administrator.
			• After you log in, the router displays the CLI prompt,
			which is described in the “CLI Prompt” section on
			page 3-6.
Step 6
	admin		Places the router in administration EXEC mode.
	Example:
	RP/0/RSP0/CPU0:router# admin
Step 7
	show dsc		Displays the RSP information for the router so that you can
	Example:		verify that you have connected successfully to the console
			port.
	RP/0/RSP0/CPU0:RO-A(admin)#sh dsc
	NODE	ROLE
	========================
	0/RSP0/CPU0	DSC
	0/RSP1/CPU0	Backup DSC
	RP/0/RSP0/CPU0:RO-A(admin)#

Configuring Gigabit Ethernet and 10-Gigabit Ethernet Interfaces

After connecting to the router, you need to configure Gigabit Ethernet and Ten Gigabit Ethernet interfaces manually. Because these interfaces are for data traffic only, not management traffic, you cannot use SSH or Telnet to an IP address that is part of the Gigabit Ethernet and 10-Gigabit Ethernet interfaces.

Where to Go Next

Once you have logged into the router, you are ready to perform general router configuration as described in Chapter 3, “Configuring General Router Features.”

	Cisco ASR 9000 Series Aggregation Services Router Getting Started Guide
OL-17502-01		1-13