EtherFast Cable/DSL Router with
D.Enter the Ethernet adapter’s IP address of the computer you want exposed to the Internet. This will bypass the NAT security for that computer. Please refer to “Appendix C: Finding the MAC Address and IP Address for Your Ethernet Adapter” for details on getting an IP address.
Once completed with the configuration, click the Save Settings button.
10.I forgot my password, or the password prompt always appears when saving settings to the Router. Reset the Router to factory default by pressing the Reset button for 30 seconds and then releasing it. If you are still getting prompted for a password when saving settings, then perform the following steps:
A.Access the Router’s web interface by going to http://192.168.1.1 or the IP address of the Router. Enter the default password admin, and click the Administration => Management tab.
B.Enter a different password in the Router Password field, and enter the same password in the second field to confirm the password.
C.Click the Save Settings button.
11.I am a PPPoE user, and I need to remove the proxy settings or the
If you have proxy settings, you need to disable these on your computer. Because the Router is the gateway for the Internet connection, the computer does not need any proxy settings to gain access. Please follow these directions to verify that you do not have any proxy settings and that the browser you use is set to connect directly to the LAN.
For Microsoft Internet Explorer 5.0 or higher:
A.Click Start, Settings, and Control Panel.
B.Click the Connections tab.
C.Click the LAN settings button and remove anything that is checked.
D.Click the OK button to go back to the previous screen.
E.Click the option Never dial a connection. This will remove any
For Netscape 4.7 or higher:
A.Start Netscape Navigator, and click Edit, Preferences, Advanced, and Proxies.
B.Make sure you have Direct connection to the Internet selected on this screen.
C.Close all the windows to finish.
12.To start over, I need to set the Router to factory default.
Hold the Reset button for up to 30 seconds and then release it. This will return the password, forwarding, and other settings on the Router to the factory default settings. In other words, the Router will revert to its original factory configuration.
Appendix A: Troubleshooting | 46 |
Common Problems and Solutions
