Cisco Systems CISCO10720 manual Troubleshooting the RPR/SRP Uplink Card Installation

Chapter 5 Troubleshooting the Uplink Cards

Troubleshooting the RPR/SRP Uplink Card Installation

Table 5-13	SRP Unwrap Message
Alarm		Description	Solution
SRP1/1 unwrapped on		Wrap cleared, Wait to Restore	None.
side B (side A Wrap cause		timer expired
cleared)

Troubleshooting the RPR/SRP Uplink Card Installation

Use the transceiver keyword to display additional information about the status of the small form-factor pluggable (SFP) module used in an RPR port.

Router# show controllers rpr-ieee 1/1 transceiver

Show Transceiver: West Span

Static information

ID: SFP transceiver

Extended ID: 4

Connector: LC

SONET compliance: OC48SR

Gigabit Ethernet compliance: unspecified

Fibre Channel link length: unspecified

Fibre Channel transmitter technology: unspecified

Fibre Channel transmission media: unspecified

Fibre Channel speed: unspecified

Encoding: reserved

Bit Rate: 2500 Mbps

Single mode fiber supported length: 2 km

Upper bit rate limit: unspecified

Lower bit rate limit: unspecified

Date code (yyyy/mm/dd): 2004/04/21

Vendor PN: SCP6828-C5-BNE

Vendor revision number: D

Vendor serial number: ECL0817001L

Transceiver status information

Diagnostics calibration is external

Temperature 39 (+/-3 Celsius)

Voltage in transceiver 3232600 uV (+/- 10 mV)

TX bias 8940 uA (+/- 100uA)

TX power 316000 nW / -5 dBm (+/- 3dBm)RX power 300200 nW / -5 dBm (+/- 3dBm)

No Active Alarms

No Active Warnings

	Alarm Thresholds:
		high			low
	Temperature	96	C		-44	C
	Voltage	4000000	uV		0	uV
	TX bias	70000	uA		0	uA
	TX power	1000000	nW / 0	dBm	50100	nW / -13 dBm
	RX power	1008300	nW / 0	dBm	unspecified
	Warning Thresholds:
		high			low
	Temperature	91	C		- 9	C
	Voltage	3600000	uV		3000000	uV
	TX bias	60000	uA		0	uA
	TX power	630900	nW / -2	dBm	79400	nW / -11 dBm
	RX power	1008300	nW / 0	dBm	unspecified
	Show Transceiver: East Span
	Book Title
5-14						78-13113-06 B0