Configuring
Note For these commands to take effect, you have to cycle the port by using the shutdown and no shutdown commands.
Note Configure the PBX to pass all
Configure the East router similar to the West router. The East router connects to the PBX through an E&M VIC port 0/1. Enter the following commands to configure a POTS dial peer for all East telephones:
East(config)#
Enter the following commands to configure a VoIP dial peer for telephones on the West router:
East(config)# | voice 221 voip |
session target ipv4:192.168.19.27 | |
exit | |
East(config)# |
|
Enter the following commands to configure number expansion and to make it easy for East users to dial numbers on the West router:
West(config)#
Finally, configure the E&M port:
East(config)#
Checking E&M Interface Configuration
If you configured the E&M interfaces correctly, you can place calls from a telephone served by one PBX to a telephone served by the other PBX (using just the extension, if you configured number expansion). If you have trouble placing calls, ping the remote router to make sure you have IP connectivity.
Note Refer to the section “Tuning Parameters for
Tuning Parameters for Real-Time Voice Traffic
Voice traffic is much more sensitive to timing variations than data traffic. For good voice performance, you need to configure your data network so that voice packets are not lost or delayed. To achieve the level of network performance needed for VoIP connections, use the following features to improve quality of service (QoS):
•IP precedence
•Resource Reservation Protocol (RSVP)
Cisco 1751
| 25 |
| |
|
|
