Cisco Systems CISCO1751 quick start Connecting the FXS, FXO, and E&M VICs to the Network

Installing WAN and Voice Interface Cards

Figure 2 Inserting a WIC or VIC in the Router

VIC	INUSE
2FXS
	1				USE
	SEE	MANUAL
			BEFORE		IN
				INSTALLATION
					0

Interface card

Model		Cisco
SLOT	1		1750
			SLOT 2
			VIC
			2FXO
SLOT	0	CONSOLE
FDX
100
LINK
10/100	ETHERNET
			AUX

Guides

IN USE
1				USE
SEE	MANUAL
		BEFORE		IN
			INSTALLATION		ACCEPTS
					THIS SLOT
				0	ONLY	VOICE
					INTERFACE
					CARDS
		PVDM OK
			MOD OK		SLOT 2 OK
						+5,	+12, -12
								VDC

46565

If you need more detailed installation instructions, refer to the Cisco WAN Interface Cards Hardware Installation Guide.

Connecting the FXS, FXO, and E&M VICs to the Network

If you installed FXS, FXO, or E&M VICs, use the following cables, and refer to Figure 3 to connect them to the network:

•Standard RJ-11 modular telephone cable to connect FXS VIC ports (color-coded gray) to a telephone or fax machine.

•Standard RJ-11 modular telephone cable to connect FXO VIC ports (color-coded pink) to the PSTN, or to a PBX that does not support E&M signaling, through a telephone wall outlet.

•Standard RJ-48S connector and cable to connect E&M VIC ports (color-coded brown) to a PBX line. The cable wiring depends on the type of connection. For details, refer to the Cisco WAN Interface Cards Hardware Installation Guide.

Cisco 1751 Voice-over-IP Quick Start Guide

4 78-11259-05