1-8
Cisco CRS-1 Carrier Routing System Multishelf System Upgrade and Conversion Guide
OL-12571-01
Chapter1 Upg rading to a Multishelf System
How to Upgrade to a Multishelf System
Step17 show platform 0/sm
slotNumber
/sp
Example:
RP/0/RP1/CPU0:router(admin)# show platform
0/sm0/sp
Displays the status of the Rack 0 fabric slot specified by
slotNumber.
Note The fabric card status appears only when the show
platform command is executed in administration
EXEC mode.
Step18 In Rack 0, attach the fabric cable connectors to the
plane that was shut down in Step Step12.
Completes the connection between a plane in the LCC and
the same plane in the FCC.
Step19 In the appropriate FCC, check the LEDs on the
appropriate OIM-LED panel for the cables connected
to the plane that is being upgraded.
Green LEDs indicate that the cables are connected
correctly.
•If the LEDs display a color other than green, see Cisco
IOS XR Getting Started Guide for information on
interpreting the LED display.
Step20 configure
Example:
RP/0/RP1/CPU0:router(admin)#configure
Places the router in administration configuration mode.
Step21 do show controllers fabric plane
planeNumber
detail
Example:
RP/0/RP1/CPU0:router(admin-config)# do show
controllers fabric plane 0 detail
Displays the status of the plane specified by planeNumber.
•Verify that a capital “P” appears in the Down Flags
column.
•Wait for the plane to come up before you continue.
Step22 no controllers fabric plane
planeNumber
shutdown
Example:
RP/0/RP1/CPU0:router(admin-config)# no
controllers fabric plane 0 shutdown
Modifies the target configuration to bring up the specified
fabric plane.
Step23 commit
Example:
RP/0/RP1/CPU0:router(admin-config)# commit
Commits the target configuration to the router running
configuration.
•This step brings up the previously shutdown plane,
which is now configured to use the FCC-SFC.
Step24 end
Example:
RP/0/RP1/CPU0:router(admin-config)# end
Changes the mode from administration configuration mode
to administration EXEC mode.
Step25 Repeat Step 9 through Step 24 for each fabric plane.
Step26 show controllers fabric plane all
Example:
RP/0/RP1/CPU0:router(admin)# show controllers
fabric plane all
Displays the administrative and operational status of all
eight fabric planes.
•Verify that all fabric planes are operational.
Command or Action Purpose