Cisco Systems DVD-ROM Replacing the CPU and Updating the License Keys, IDE Configuration Screen

How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM

If the server does not boot up (you cannot get into the Setup mode on the monitor), contact Cisco TAC as described in the “Obtaining Technical Assistance” section on page 18 before you proceed to the “Replacing the CPU and Updating the License Keys” section on page 12.

Step 5 In Setup mode, press the right arrow to choose the Advanced menu.

Step 6 By using the Down arrow, choose IDE Configuration and press Enter.

Step 7 Verify that the Local Bus IDE field is set to Both, as shown in Figure 12. To exit, press ESC.

Note Do not save when you are prompted.

Figure 12 IDE Configuration Screen

Should be set to“Both”

Step 8 If the Cisco MeetingPlace 8112 comes up after exiting the BIOS, proceed to the “Installing the DVD-ROM Drive into the Cisco MeetingPlace 8112” section on page 7.

or

If the server does not come up after exiting the BIOS, contact Cisco TAC as described in the “Obtaining Technical Assistance” section on page 18 before you proceed to the “Replacing the CPU and Updating the License Keys” section on page 12.

Replacing the CPU and Updating the License Keys

To replace the CPU and update the license keys, perform the following steps:

	Step 1	Obtain new license keys by contacting Cisco TAC.
	Step 2	Verify that the power is off on the Cisco MeetingPlace 8112 and your laptop is connected to the service
		port on the front of the server with the null-modem cable.
	Step 3	Remove the old CPU card and replace it with the new CPU card.
	Step 4	Place the old CPU card in the anti-static bag from which you removed the new CPU card.
	Step 5	Power up the server.
	Step 6	Log in as a technician.
	Step 7	Check for alarms.
	Step 8	Verify that there is a modem line connected to the server.
	Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure
12		78-16489-01