Configuring LAN Interfaces
Configuring a Fiber Distributed Data Interface
Modifying the TB-Min Timer
You can change the
Command | Purpose |
|
|
fddi | Sets |
|
|
Modifying the FDDI Timeout Timer
You can change the FDDI timeout timer in the PCM from its default value of 100 ms. To do so, use the following command in interface configuration mode:
Command | Purpose |
|
|
fddi | Sets the timeout timer in the PCM. |
|
|
Controlling SMT Frame Processing
You can disable and enable SMT frame processing for diagnostic purposes. To do so, use one of the following commands in interface configuration mode:
Command | Purpose |
|
|
no fddi | Disables SMT frame processing. |
|
|
fddi | Enables SMT frame processing. |
|
|
Enabling Duplicate Address Checking
You can enable the duplicate address detection capability on the FDDI. If the FDDI finds a duplicate address, it displays an error message and shuts down the interface. To enable duplicate address checking, use the following command in interface configuration mode:
Command | Purpose |
|
|
fddi | Enables duplicate address checking capability. |
|
|
Setting the Bit Control
You can set the FDDI bit control to control the information transmitted during the Connection Management (CMT) signaling phase. To do so, use the following command in interface configuration mode:
Command | Purpose |
|
|
fddi | Sets the FDDI bit control. |
|
|
Cisco IOS Interface Configuration Guide