Configuring LAN Interfaces
Configuring an Ethernet or Fast Ethernet Interface
Monitoring and Maintaining the PA-12E/2FE Port Adapter
After configuring the new interface, you can display its status and verify other information. To display information about the
Command | Purpose |
|
|
show version | Displays the configuration of the system hardware, the software version, |
| the names and sources of configuration files, and the boot image. |
|
|
show controllers | Displays all current port adapters and their interfaces |
|
|
show interface fastethernet slot/port | Displays the interfaces so you can verify that they have the correct slot |
(ports 0 and 1) | number and that the interface and line protocol are in the correct state. |
or |
|
show interface ethernet slot/port |
|
(ports 2 through 13) |
|
|
|
show bridge group | Displays all bridge groups and their interfaces. |
|
|
show interface ethernet slot/port irb | Displays the routed protocol so you can verify that it is configured |
(ports 2 through 13) | correctly for each interface. |
or |
|
show interface fastethernet slot/port irb |
|
(ports 0 and 1) |
|
|
|
show protocols | Displays the protocols configured for the entire system and specific |
| interfaces. |
|
|
show pas eswitch addresses fastethernet | Displays the Layer 2 learned addresses for each interface. |
slot/port |
|
(ports 0 and 1) |
|
or |
|
show pas eswitch addresses ethernet |
|
slot/port |
|
(ports 2 through 13) |
|
|
|
more | Displays the running configuration file. |
|
|
more | Displays the configuration stored in NVRAM. |
|
|
Configuring Bridge Groups Using the 12E/2FE VLAN Configuration WebTool
The 12E/2FE VLAN Configuration WebTool, shown in Figure 2, is a web
•Create and delete bridge groups (also referred to as VLANs)
•Add and remove
•Assign colors to bridge groups and
•Administratively shut down (disable) and bring up (enable)
•View the
Cisco IOS Interface Configuration Guide