Configuring LAN Interfaces
LAN Interface Configuration Examples
Configuring PCbus Token Ring Interface Management
The Token Ring interface on the AccessPro PC card can be managed by a remote LAN manager over the PCbus interface. Currently, the LanOptics Hub Networking Management software running on an
To enable LanOptics Hub Networking Management of a PCbus Token Ring interface, use the following command in interface configuration mode:
Command
Purpose
Enables PCbus LAN management.
Enabling Token Ring Concentrator Port
To enable an interface to operate as a concentrator port, use the following command in interface configuration mode:
Command
port
Purpose
Specifies concentrator port operation.
Monitoring and Maintaining the Port
To monitor the Token Ring Concentrator Port, use one or more of the following commands in EXEC mode:
Command | Purpose | |
|
|
|
show | controllers token | Displays internal state information about the Token Ring interfaces in the |
|
| system. |
|
|
|
show | interface token | Displays |
|
|
|
LAN Interface Configuration Examples
This section provides examples to illustrate configuration tasks described in this chapter. The following examples are included:
•Ethernet Encapsulation Enablement Example
•Full Duplex Enablement Operation Example
•
•
•Fast EtherChannel Configuration Examples
•FDDI Frames Configuration Example
•Hub Configuration Examples
•LAN Extender Enablement Interface Example
•LAN Extender Interface Access List Examples
Cisco IOS Interface Configuration Guide